Compressed Air Systems, Inc.
Compressed Air Systems, Inc.
9303 Stannum StreetTampa, FL 33619-2658
Toll: 855.464.8525
Ph: 813.626.8177
Fx: 813.628.0187
Email: [email protected]
Print Back
CAS Industrial-duty gas and diesel compressors are designed for applications that require air on the go. Built for durability and reliability with features designed to make these compressors simpler to use and easier to maintain than any other compressor in this class. The engine is standard on the drivers side of the vehicle. The unloader is at your finger tips so you can unload the compressor before starting to increase solenoid and starter life. The transfer tube is protected by the receiver for safety.

With the capacity to run 1-inch impact wrenches along with any assortment of air tools, this is the compressor you need to get the job done.
Unit of Measure

Financing

Approve Payments

 N/A Finance with Approve Payments

Specifications

Shipping Weight

 N/A 450 lbs450 lb

Horsepower

 N/A 14 hp

Flow at 175 psi

 N/A 24 cfm

Drive Engine

 N/A Kohler

Tank

 N/A (H) 30 gallon

Dimensions (L x W x H)

 N/A 44 x 24 x 40 inches

Features

Features

 N/A

Standard Features:

  • Access to compressor valves without compressor head removal

  • Alternator on drive engine

  • ASME tested powder coated steel tank

  • Bearings on both ends of the crank shaft

  • Centrifugal unloader

  • Critical controls protected by compressor base plate

  • Disk and spring valves

  • Drive engine on left side for safety

  • Fully enclosed belt guard

  • Full saddle mounting feet instead of pegged mounting feet

  • Heavy-duty air filter

  • Heavy-duty two-stage solid cast iron pump

  • Industrial-duty engine

  • Needle bearings, and inserts on rods

  • Pilot valve continuous operation

  • Stainless steel flex air lines

  • Swedish steel valves

  • Torrington needle bearings

  • 2-grove B width drive pulley

Standard Features:

  • Access to compressor valves without compressor head removal

  • Alternator on drive engine

  • ASME tested powder coated steel tank

  • Bearings on both ends of the crank shaft

  • Centrifugal unloader

  • Critical controls protected by compressor base plate

  • Disk and spring valves

  • Drive engine on left side for safety

  • Fully enclosed belt guard

  • Full saddle mounting feet instead of pegged mounting feet

  • Heavy-duty air filter

  • Heavy-duty two-stage solid cast iron pump

  • Industrial-duty engine

  • Needle bearings, and inserts on rods

  • Pilot valve continuous operation

  • Stainless steel flex air lines

  • Swedish steel valves

  • Torrington needle bearings

  • 2-grove B width drive pulley

Options

Options

 N/A
  • Automatic tank drain
  • Battery mounted and wired
  • Belt guard aftercooler
  • Filter Regulator