Print Back

The VMAC’s line of hydraulic driven air compressors (H40 & H60) is ready to produce air with your supply of hydraulic power. VMAC’s hydraulic driven air compressors are the best choice for customers looking for compact, powerful, and lightweight hydraulic deck-mount air compressors that can operate in any climate. Simply connect your pressure and return lines to the hydraulic manifold on the VMAC Hydraulic Air Compressor and you're ready to go. Of course you'll need between 9 and 12 GPM to for the H40 and between 14-21 GPM for the H60, depending on your air CFM requirements.

Once you have the hydraulic fluid running through the system, turn the compressor on with the on button or remote start/stop and the integral digital control takes care of the rest.  A 12-volt solenoid will open and allow the hydraulic oil to travel into the hydraulic motor, thus starting the compressor.  The motor is directly coupled to the compressor via a SAE B spline drive.  Unlike other above deck compressors, there isn’t a belt or pulley system.  Once the oil travels through the motor it is cooled within the integral cooler.  A 12-volt fan cycles with the temperature of the compressor to keep things cool. 
 
The cooler provides cooling for the compressor oil, as well as your hydraulic oil.  There is ample cooling to keep the system cool, if the compressor is the only component running.  Additional hydraulically powered equipment may require separate cooling sources.
 
The compressor itself works just like the UNDERHOOD™ 70 compressor. Compressor oil is injected into the rotor housing to provide a seal between the rotors.  The oil/air mixture then flows into the air/oil separator tank where baffles and air direction changes remove much of the oil from the air stream. A coalescing filter at the discharge end of the tank then removes oil mist left in the air stream.  The oil then travels through the cooler and is returned to the compressor to once again provide the seal between the rotors. 

The inlet control valve works in the same fashion as the UNDERHOOD™ compressors as well.  When the system reaches full pressure, the inlet will close and prevent further air from being brought into the system.  A pressure drop caused by the use of your tools will allow the inlet to open and generate a steady flow of air equal to your requirements.
 
Traditional safety systems are incorporated into the VMAC H40 and H60. A 200 psi safety valve is located at the back of the tank to prevent over pressurizing the system.  As well, a temperature probe will send a signal to the control box to shut the system down if an over-temp situation occurs. On the hydraulic side there’s also a temperature prob for over-temp situations, and a 2,650 psi safety valve prevents too much hydraulic pressure from entering the system.
 
The digital control box controls includes an hour meter, service reminders, and diagnostics. It not only the on/off function, but also controls the cycling of the electric fan, monitors regulated system pressure to activate the Speed 2 wire if used and monitors the compressor oil temperature. If the hydraulic oil becomes too hot, the system will shut down and if the compressor oil is too cold, the system will not turn on until the hydraulic oil heats to a sufficient temperature.
 
The VMAC Hydraulic Driven Air Compressor combines all of these features in a very compact, light weight package that delivers up to 40 CFM or 60CFM of air for your job.

VMAC Hydraulic Driven Air Compressors
1 

Item #

Item Name

Web Price

H400001 N/A H40 Quote
H600002 N/A H60 Quote
1