The AIR-SAVER 1" is installed in the compressed air line after the air receiver. The AIR-SAVER 1" opens and closes the air supply to the factory, based on customer specific working shifts.
A typical compressed air system has air loss through pipe work connections, leaking float type drains, etc.
The AIR-SAVER 1" will open the ball valve at the beginning of a working shift and close the ball valve when the working shift is over. From that point on, all compressed air will remain in the air receiver until the next working shift, rather than being lost through leakages.
The clever and versatile programming feature allows for customer specific settings and is totally adaptable to the working hours of each individual factory.
The AIR-SAVER 1" can be installed in all pipe line systems up to 1". Remote switching kits are available to operate the AIR-SAVER 1" from a distance.
N/AMaximum 100 Switching Point to be Distributed Over 1-7 days Week Planner
Inlet/Outlet Connections
N/A1 in. National Pipe Thread (NPT) British Standard Pipe (BSP)
Valve Housing Material
N/ABrass Nickel Plated
Serviceable Valve
N/Atrue
Manual Override
N/Atrue
Remote Controllable
N/Atrue
Environmental Protection
N/ANational Electrical Manufacturers Association (NEMA13) (Ingress Protection (IP54))
Supply Voltage Options
Alternating Current (AC) Voltage
N/A115 V230 V
Frequency
N/A50 Hz60 Hz
Note for Supply Voltage Options
N/APlease Indicate
Commercial Benefits
Commercial Benefits
N/A
At least one air receiver’s worth of compressed air savings per day
No unnecessary compressor start-up during periods when compressed air is not required
Compressor, dryer and filter activities are reduced during factory closing hours
Possibility to shut of parts of the pipe line system where compressed air is not needed continuously
Language selection feature (English, German, Spanish, French and Dutch)
Each individual day can be programmed according to specific working day shift requirements
Time programmed or remote controlled
Manual valve opening and closing possible, in case of a power failure
Consult Jorc for private labelling options
Technical Advantages
Technical Advantages
N/A
Microprocessor controlled (7 day program feature - multiple cycles possible each day)
Extended programming features relating to valve open and close cycles (100)
Slow ball valve rotation 90° in 30 seconds to avoid “water hammer” when opening or closing
Stainless steel ball, valve is nickel plated brass
Battery saves the installation set-up during power failure
Battery life indication in the display
Compact design - Easy to install
Note
Note
N/AInformation provided herewith is believed to be accurate and reliable. However, no responsibility is assumed for its use or for any infringement of patents or rights of others, which may result from its use. In addition, Jorc reserves the right to revise information without notice and without incurring any obligation.